FUDforum
Fast Uncompromising Discussions. FUDforum will get your users talking.

Home » Imported messages » comp.lang.php » where else can this list be found?
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: where else can this list be found? [message #170646 is a reply to message #170644] Sat, 13 November 2010 03:38 Go to previous messageGo to previous message
richard is currently offline  richard   
Messages: 213
Registered: June 2013
Karma:
Senior Member
On Fri, 12 Nov 2010 18:50:09 -0800, Mike S wrote:

> On 11/12/2010 1:57 PM, richard wrote:
>> http://krakjoe.com/geoip/query=code&address=remote
>>
>> I found this code I would like to use as a spam blocker.
>> Since it calls the information from a file rather than an array.
>> I could make up my own file to install on my site.
>> I just need to know where I can get the same basic information as this site
>> is apparently gone.
>>
>> <?php
>> # array of country codes you wanna block
>> $block_countries = array(
>> 'GB',
>> 'US'
>> );
>> # grab the country code from krakjoe.com
>> if( !in_array( file_get_contents(
>> 'http://krakjoe.com/geoip/query=code&address=remote' ), $block_countries )
>> ) :
>> # the following page will only be displayed to users who have a country
>> code that is NOT in the array at the top of the example
>> ?>
>> <html>
>> <head>
>> <title>You're allowed to view this page</title>
>> </head>
>> <body>
>> viewing the page, oh yeah baby .....
>> </body>
>> </html>
>> <?php
>> endif;
>> ?>
>>
>>
>> I would change the !in_array to in_array then send those blocked to a
>> specific page before they even get into my forum site.
>
> Will these get you started: 2 pages with easy to grab data, and the
> wikipedia page about it:
>
> English country names and code elements
>
> This list states the country names (official short names in English) in
> alphabetical order as given in ISO 3166-1 and the corresponding ISO
> 3166-1-alpha-2 code elements.
> This list is updated whenever a change to the official code list in ISO
> 3166-1 is effected by the ISO 3166/MA.
> It lists 246 official short names and code elements.
>
> http://www.iso.org/iso/english_country_names_and_code_elements
> -----------------------------------------------------------------------
> Country Codes
>
> The International Organization for Standardization (ISO) under its
> standard ISO 3166 has established two-letter (2-alpha) and three-letter
> (3-alpha) codes for the various countries of the world, including
> independent states, dependent areas, and certain areas of contested
> jurisdiction or special status. These codes are published and revised
> when needed by the ISO 3166 Maintenance Agency.
>
> http://www.unc.edu/~rowlett/units/codes/country.htm
> -----------------------------------------------------------------------
> ISO 3166-1 alpha-2
>
> ISO 3166-1 alpha-2 codes are two-letter country codes defined in ISO
> 3166-1, part of the ISO 3166 standard published by the International
> Organization for Standardization (ISO), to represent countries,
> dependent territories, and special areas of geographical interest. They
> are the most widely used of the country codes published by ISO (the
> others being alpha-3 and numeric), and are used most prominently for the
> Internet's country code top-level domains (with a few exceptions).[1]
> They were first included as part of the ISO 3166 standard in its first
> edition in 1974
>
> http://en.wikipedia.org/wiki/ISO_3166-1_alpha-2

Perhaps I should ask, how could I resolve an IP to a country code?

In my forum, I recently revamped my spammer IP list and wound up with
basically 50 main ip's that cover what I don't want in.
Problem is, the way it is set up, the IP block doesn't take effect until
the visitor does something, such as trying to register.
What I want to do is to check the IP from the beginning, and if it's on the
list, kick them off to another page.

I've seen a few sites that show how to do this but none show how to do it
with a wildcard scheme. With this script, using the external file would
help a lot.

Got any sites that would show how to use the wildcard scheme properly?
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Why don't I get a deprecation warning?
Next Topic: Variable expansion <?=$foo?> not working anymore
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 23 04:54:56 GMT 2024

Total time taken to generate the page: 0.05076 seconds