Re: getting only the temperature & general weather condition [message #173822 is a reply to message #173815] |
Sat, 07 May 2011 10:21 |
Evolution
Messages: 14 Registered: April 2011
Karma:
|
Junior Member |
|
|
On May 6, 6:23 pm, Jerry Stuckle <jstuck...@attglobal.net> wrote:
> On 5/6/2011 6:22 PM, Evolution wrote:
>
>
>
>
>
>> On phpbuilder.com, I found the following:
>
>> http://www.phpbuilder.com/board/showthread.php?t=10283087
>
>> which discusses how to obtain the current weather for a feed closest
>> to you.
>
>> I modified the code to my site but didn't get the same results as
>> shown by Kudose (a poster at the bottom of that same page).
>
>> My code is:
>> <?
>> session_register();
>> session_start();
>> $url = 'http://www.nws.noaa.gov/data/current_obs/KSBA.xml';
>> $xml = simplexml_load_file($url);
>
>> echo '<b>Santa Barbara weather:</b><br />';
>> echo $xml->weather, '<br />';
>> echo $xml->temperature_string, '<br />';
>> echo $xml->relative_humidity, '% humidity<br />';
>> ?>
>
>> and the impaired results are on a test page at:
>
>> http://www.geol.ucsb.edu/library/php/weather.php
>
>> Can anybody point me in the right direction? I'm essentially a
>> newbie.
>> Thanks!
>
> The code works for me.
>
> --
> ==================
> Remove the "x" from my email address
> Jerry Stuckle
> JDS Computer Training Corp.
> jstuck...@attglobal.net
> ==================
Wow! What could make this possible if I am using PHP5 and my browser
fails but yours doesn't?
|
|
|